Support
Need a hand with your GlowUpLED lights? The quickest way is inside the app: open Account (your initials, top right) and use Need help?. That sends us your details and what you tried, so we can pick up where you left off. You can also email [email protected].
Setting up a new light
- Power on your light. It makes its own WiFi network called GlowUpLED- followed by four letters or numbers (also on the label on the box).
- On your phone go to Settings → WiFi and join it. The password is on the label.
- Your phone may say it "couldn't join", or open a page about the light. That is normal. Wait a few seconds, check the light's name is ticked in your WiFi list, and if a page opens tap Cancel, then Use Without Internet.
- Open the GlowUpLED app. It will say New light found. Tap Set up, choose your home WiFi, enter its password, and tap Connect.
- After about a minute the light joins your WiFi. Switch your phone back to your home WiFi and open the app. Your light appears under Nearby lights.
Common questions
My light isn't in the Nearby list.
Check your phone is on the same WiFi as the light, then open the app again. If you still don't see it, open Account → Light diagnostics after connecting by address, or email us.
My phone keeps leaving the light's WiFi during setup.
Phones prefer WiFi that has internet. During setup, turn off Auto-Join for your home network (Settings → WiFi → the ⓘ next to it), and remember to turn it back on afterwards.
The light went back to setup mode.
That usually means it couldn't join your WiFi, most often a mistyped password. Join its own network again and repeat the setup. Tap the eye icon on the password box to check what you typed.
What does my light do after a power cut?
It comes back the way you left it. To go back to the soft warm-white factory look, open Account → Light diagnostics → Reset to default look.
How do I delete my account?
In the app: Account → Delete my account. See our privacy policy for what that removes.
Still stuck?
Email [email protected] with your light's name (GlowUpLED- and four characters, on its label) and what you see on screen. A screenshot helps.